drivetrains RSS

  1. Maytech New 72V VESC Controller MTSVESC7.5R Round VESC based on VESC6.0 Hardware for Electric Skateboard Longboard Model No. MTSVESC7.5R Cont. Current 50A Burst Current 100A Input Voltage 72V Hardware Based on VESC6.0 Firmware  Updatable  Software VESC_TOOL Compatible FOC  Yes, can work  Size  Round Shape 88mm diameter * 22mm height Compatible Motor Sensored / Sensorless Motor   2. Maytech NEW 10S 42V VESC6.0 based Controller MTSVESC6.0M 30A VESC for Electric Skateboard E-scooter Model No. MTSVESC6.0M Cont. Current 30A Burst Current 50A Input Voltage 42V(10S) Hardware Based on VESC6.0 Firmware  Updatable  Software VESC_TOOL Compatible FOC  Yes, can work  Size  65mm*20mm   Compatible...

Read more

How to Install Motor on MTSKT310DB Dual Belt-driven Truck? Check below Video: New Gravity Casting Technology: 1. Aluminum liquid flow into truck mould by liquid's weight naturally, this way can delete mould's inside air clearly.2. do heat treatment after demoulding (truck surface is a little rough because of heat treatment). Prouction time is longer than old die casting technology, and the production cost is twice than before.3. Hardness reached out HRB65 around, which can stand over 150kg weight for professional skateboarders.     Compatible Motor: 5055/5065/6355/6365/6374 Motor Mount: 30mm and 44mm hole distance  1. Maytech Brushless Outrunner Sensored Motors 2....

Read more

1. Remote Apperance: 2. Receiver wiring instruction with VESC or VESC based Controllers:  There's 2 ways to connect receiver and VESC: 1. Connect VESC signal cable to receiver PWM; 5V; GND (as above receiver pin definition) 2. You can also use UART:  Cross connection of Receiver TXD/RXD and VESC RX/TX: Receiver’s TXD>> VESC RX;Receiver RXD>> VESC TX, 5V and GND also need to be connected, better use stranded wire, wire length should be shorter than 20cm. VESC supports UARR and PWM(PPM) throttle control. When use with Maytech waterproof remote, you can select PPM and UART, and select corresponding control in remote...

Read more

  How to test motor KV with VESC? KV must test without load. To compatible with different kinds VESC, The default parameters are more conservative in the design of the motor running speed, if test by VESC, test value would be lower about 5% than actual value. Test KV would be different under different mode and parameters, KV would be higher when test in following situations: with hall sensor, high angle, FOC higher than in BLDC, V6 higher than V6.   What is KV? KV is unload rotation speed (RPM) per Voltage, which is the increasing speed value of brushless...

Read more

What is brushless motor? A brushless DC electric motor (BLDC motor or BL motor), also known as electronically commutated motor (ECM or EC motor) and synchronous DC motors, are synchronous motors powered by direct current (DC) electricity via an inverter or switching power supply which produces electricity in the form of alternating current (AC) to drive each phase of the motor via a closed loop controller. The controller provides pulses of current to the motor windings that control the speed and torque of the motor. The construction of a brushless motor system is typically similar to a permanent magnet synchronous...

Read more