electric surfboard hydrofoil RSS

Firstly, you need to prepare below tools to help:  1. Silicone cable that you need to use.  2. Heat shrink tube that is suitable for your cable.  3. Torx screwdriver. 4. Wire cutters to cut the rubber on silicone wires.  5. Terminal hydraulic pliers to crimp terminal connector.   Steps: 1. Use torx screwdriver to unscrew the screws and terminal connector on switch.  2. Use wire cutters to cut about 5mm length rubber on silicone wires.  3. Connect the conductive end on the silicone cable to connetion port on terminal connector.  4. Use terminal hydraulic pliers to crimp terminal connector on silicone cable...

Read more

If can't pair MTSKR1905WF remote with our 300A ESC successfully, might has below reasons: 1. Please check if the receiver or ESC power (Internal receiver version) is always on. Before pairing, please make sure the receiver power or ESC (Internal receiver version) power is off first, then turn on the remote screen and "Pair" in main menu until 【Pairing...】shows on the screen, and then turn on the receiver or ESC (internal receiver version) power, remote will pair automatically in about 0.5 seconds.  2. Some customers all above pairing steps are correct, but still can't pair successfully, Why? Our 300A ESC...

Read more

When you received the MTSKR1905WF / MTSKR2005WF remote, firstly you need to connect receiver to your VESC / ESC, and pair the remote with receiver.  1. If you use VESC with built-in BEC, then just need to connect the throttle wire on ESC to receiver PWM port, receiver port definition as below, same as both MTSKR2005WF and MTSKR1905WF:      2. If you use OPTO without built-in 5V BEC, then you also need to add a 5V UBEC to power the receiver, wiring diagram as below:        3. After connected correctly, then do pair steps as below:  Firstly,...

Read more

We've got many times about this questions: How can I set the ESC values for my Efoil, today we will talk about this.  1. If you use our 300A ESC to work with our motor, then suggest you use the default values, because our engineer had already adjusted the values to make them work properly before shipment.  Default values is as below:  2. In second situation, if you use our ESC to work with other brands motors, you can use the default value to test at first, if not working, then you can try to adjust the values by progcard...

Read more