Esk8 RSS

When you received the MTSKR1905WF / MTSKR2005WF remote, firstly you need to connect receiver to your VESC / ESC, and pair the remote with receiver.  1. If you use VESC with built-in BEC, then just need to connect the throttle wire on ESC to receiver PWM port, receiver port definition as below, same as both MTSKR2005WF and MTSKR1905WF:      2. If you use OPTO without built-in 5V BEC, then you also need to add a 5V UBEC to power the receiver, wiring diagram as below:        3. After connected correctly, then do pair steps as below:  Firstly,...

Read more

  1. Maytech New 72V VESC Controller MTSVESC7.5R Round VESC based on VESC6.0 Hardware for Electric Skateboard Longboard Model No. MTSVESC7.5R Cont. Current 50A Burst Current 100A Input Voltage 72V Hardware Based on VESC6.0 Firmware  Updatable  Software VESC_TOOL Compatible FOC  Yes, can work  Size  Round Shape 88mm diameter * 22mm height Compatible Motor Sensored / Sensorless Motor   2. Maytech NEW 10S 42V VESC6.0 based Controller MTSVESC6.0M 30A VESC for Electric Skateboard E-scooter Model No. MTSVESC6.0M Cont. Current 30A Burst Current 50A Input Voltage 42V(10S) Hardware Based on VESC6.0 Firmware  Updatable  Software VESC_TOOL Compatible FOC  Yes, can work  Size  65mm*20mm   Compatible...

Read more

1. If a vehicle does not need mechanical brakes, but must be able to brake, it must use electronic brakes. The principle is that the kinetic energy on the motor and the load can be used as a generator through the DC motor to convert the kinetic energy into electrical energy. Then the electric energy is consumed by heating and charging.   2. The electric energy that is emitted must not only charge the battery, but also release the heat. What is the process? 2.1 At this time, VESC has to make a distribution, which current is used to charge...

Read more

How to Install Motor on MTSKT310DB Dual Belt-driven Truck? Check below Video: New Gravity Casting Technology: 1. Aluminum liquid flow into truck mould by liquid's weight naturally, this way can delete mould's inside air clearly.2. do heat treatment after demoulding (truck surface is a little rough because of heat treatment). Prouction time is longer than old die casting technology, and the production cost is twice than before.3. Hardness reached out HRB65 around, which can stand over 150kg weight for professional skateboarders.     Compatible Motor: 5055/5065/6355/6365/6374 Motor Mount: 30mm and 44mm hole distance  1. Maytech Brushless Outrunner Sensored Motors 2....

Read more

1. Remote Apperance: 2. Receiver wiring instruction with VESC or VESC based Controllers:  There's 2 ways to connect receiver and VESC: 1. Connect VESC signal cable to receiver PWM; 5V; GND (as above receiver pin definition) 2. You can also use UART:  Cross connection of Receiver TXD/RXD and VESC RX/TX: Receiver’s TXD>> VESC RX;Receiver RXD>> VESC TX, 5V and GND also need to be connected, better use stranded wire, wire length should be shorter than 20cm. VESC supports UARR and PWM(PPM) throttle control. When use with Maytech waterproof remote, you can select PPM and UART, and select corresponding control in remote...

Read more