remote control RSS

If can't pair MTSKR1905WF remote with our 300A ESC successfully, might has below reasons: 1. Please check if the receiver or ESC power (Internal receiver version) is always on. Before pairing, please make sure the receiver power or ESC (Internal receiver version) power is off first, then turn on the remote screen and "Pair" in main menu until 【Pairing...】shows on the screen, and then turn on the receiver or ESC (internal receiver version) power, remote will pair automatically in about 0.5 seconds.  2. Some customers all above pairing steps are correct, but still can't pair successfully, Why? Our 300A ESC...

Read more

The MTSKR2005WF remote has one 30V 3A Relay mechanical switch and one 20V 2A transistor electronics switch for esk8 lights, etc.  1. Relay Switch:  -When relay switch is in original position(no display of ① in Main interface) , COM(common point) and CLO(normally close) are connected. -When Short press Function button 3 times (display of ① in Main interface) , COM(common point) and OPE(normally open) are connected. Short press Function Button 3 times, relay switch is off. 2. Transistor Switch:  Short press Function button 4 times , ② will display on main interface, transistor switch source will be connected to GND and turn on LED. Short press...

Read more

1. Remote Apperance: 2. Receiver wiring instruction with VESC or VESC based Controllers:  There's 2 ways to connect receiver and VESC: 1. Connect VESC signal cable to receiver PWM; 5V; GND (as above receiver pin definition) 2. You can also use UART:  Cross connection of Receiver TXD/RXD and VESC RX/TX: Receiver’s TXD>> VESC RX;Receiver RXD>> VESC TX, 5V and GND also need to be connected, better use stranded wire, wire length should be shorter than 20cm. VESC supports UARR and PWM(PPM) throttle control. When use with Maytech waterproof remote, you can select PPM and UART, and select corresponding control in remote...

Read more

MTSKR2005WF is designed only for electric skateboard application, please do not use for electric surfboard.  Difference between MTSKR1905WF and MTSKR2005WF, check below chart: Can I use the MTSKR2005WF on electric surfboard? No, MTSKR2005WF only has Esk8 mode, don't have Esurf mode, no cruise control mode; Besides, MTSKR2005WF remote is only IP67 waterproof, enough for electric skateboard usage, but not enough for electric surfboard, MTSKR1905WF inside circuit is not only with glued, but also with nanometer coating double waterproof, and the screen is with 2 layers waterproof screen; At last, the throttle Zero is different, can't compatible with Esurf application. 

Read more