remote control robotics RSS

If can't pair MTSKR1905WF remote with our 300A ESC successfully, might has below reasons: 1. Please check if the receiver or ESC power (Internal receiver version) is always on. Before pairing, please make sure the receiver power or ESC (Internal receiver version) power is off first, then turn on the remote screen and "Pair" in main menu until 【Pairing...】shows on the screen, and then turn on the receiver or ESC (internal receiver version) power, remote will pair automatically in about 0.5 seconds.  2. Some customers all above pairing steps are correct, but still can't pair successfully, Why? Our 300A ESC...

Read more

The MTSKR2005WF remote has one 30V 3A Relay mechanical switch and one 20V 2A transistor electronics switch for esk8 lights, etc.  1. Relay Switch:  -When relay switch is in original position(no display of ① in Main interface) , COM(common point) and CLO(normally close) are connected. -When Short press Function button 3 times (display of ① in Main interface) , COM(common point) and OPE(normally open) are connected. Short press Function Button 3 times, relay switch is off. 2. Transistor Switch:  Short press Function button 4 times , ② will display on main interface, transistor switch source will be connected to GND and turn on LED. Short press...

Read more

When you received the MTSKR1905WF / MTSKR2005WF remote, firstly you need to connect receiver to your VESC / ESC, and pair the remote with receiver.  1. If you use VESC with built-in BEC, then just need to connect the throttle wire on ESC to receiver PWM port, receiver port definition as below, same as both MTSKR2005WF and MTSKR1905WF:      2. If you use OPTO without built-in 5V BEC, then you also need to add a 5V UBEC to power the receiver, wiring diagram as below:        3. After connected correctly, then do pair steps as below:  Firstly,...

Read more

  How to test motor KV with VESC? KV must test without load. To compatible with different kinds VESC, The default parameters are more conservative in the design of the motor running speed, if test by VESC, test value would be lower about 5% than actual value. Test KV would be different under different mode and parameters, KV would be higher when test in following situations: with hall sensor, high angle, FOC higher than in BLDC, V6 higher than V6.   What is KV? KV is unload rotation speed (RPM) per Voltage, which is the increasing speed value of brushless...

Read more

Some customers may ask: I still can't successful connect VESC to VESC_TOOL after VESC driver is installed, what should I do? After VESC driver is installed, doesn't mean the VESC is successfully installed, you need to choose correct virual serial port number in VESC_TOOL, if the virtual port number choose incorrect, still can't correct, check below steps: 1. When you first connect VESC to VESC_TOOL or when firmware is updated, driver will be installed automatically, please make sure your computer has network. (If the driver does not installed automatically, check former article,3 Ways to Install VESC Driver?) 2. After driver...

Read more