Robot fight RSS

  1. Maytech New 72V VESC Controller MTSVESC7.5R Round VESC based on VESC6.0 Hardware for Electric Skateboard Longboard Model No. MTSVESC7.5R Cont. Current 50A Burst Current 100A Input Voltage 72V Hardware Based on VESC6.0 Firmware  Updatable  Software VESC_TOOL Compatible FOC  Yes, can work  Size  Round Shape 88mm diameter * 22mm height Compatible Motor Sensored / Sensorless Motor   2. Maytech NEW 10S 42V VESC6.0 based Controller MTSVESC6.0M 30A VESC for Electric Skateboard E-scooter Model No. MTSVESC6.0M Cont. Current 30A Burst Current 50A Input Voltage 42V(10S) Hardware Based on VESC6.0 Firmware  Updatable  Software VESC_TOOL Compatible FOC  Yes, can work  Size  65mm*20mm   Compatible...

Read more

  How to test motor KV with VESC? KV must test without load. To compatible with different kinds VESC, The default parameters are more conservative in the design of the motor running speed, if test by VESC, test value would be lower about 5% than actual value. Test KV would be different under different mode and parameters, KV would be higher when test in following situations: with hall sensor, high angle, FOC higher than in BLDC, V6 higher than V6.   What is KV? KV is unload rotation speed (RPM) per Voltage, which is the increasing speed value of brushless...

Read more

How to install VESC Driver in Windows system? When you receive a VESC and is trying to use VESC_TOOL to program, you may find VESC_TOOL couldn’t identify USB serial port, you may think this is USB cable or VESC problem, don’t panic, below is the answer: First thing you need to know: when you connect VESC to your computer with USB cable, VESC driver is required to be installed to connect VESC to your computer, so that you can adjust parameters in VESC_TOOL. So when you connect VESC to computer with USB cable but VESC_TOOL couldn’t find USB serial port, don’t...

Read more

Inf. File download link: https://cdn.shopify.com/s/files/1/0089/3065/6320/files/VESCDrivers.rar?v=1592371404   First Step: download the file in the above link, unzip the file Open Device Manager in your computer, find the device corresponding to the inserted USB device, if has no corresponding driver program, you’ll see an exclamation mark behind the device name, choose this device, right-click and select “Update Driver Program” Second Step: Choose “Browse your computer to find driver software” Third Step: Choose file folder with inf. File and install, remember to unzip you download. Forth Step: Go next and install And done:   There are totally 3 installation methods for VESC Driver:...

Read more

The answer is no, here's 2 reasons: 1. Because switching power supply voltage can reach to 300V at the moment of power connected, then switching power need to adjust voltage to specific voltage (such as 20V, 35V), most switching power has slow response, the 300V voltage will directly burn controller driver chip and MCU, also may cause capacitor swell.   2. Connect power first (for example 35V), connect load, when load weight is too high, voltage will decrease (almost 30V),at this time switching power supply need to increase voltage to specific value (35V), but load weight is constantly changing, if load...

Read more