underwater brushless motor RSS

We've got many times about this questions: How can I set the ESC values for my Efoil, today we will talk about this.  1. If you use our 300A ESC to work with our motor, then suggest you use the default values, because our engineer had already adjusted the values to make them work properly before shipment.  Default values is as below:  2. In second situation, if you use our ESC to work with other brands motors, you can use the default value to test at first, if not working, then you can try to adjust the values by progcard...

Read more

How to Install Motor on MTSKT310DB Dual Belt-driven Truck? Check below Video: New Gravity Casting Technology: 1. Aluminum liquid flow into truck mould by liquid's weight naturally, this way can delete mould's inside air clearly.2. do heat treatment after demoulding (truck surface is a little rough because of heat treatment). Prouction time is longer than old die casting technology, and the production cost is twice than before.3. Hardness reached out HRB65 around, which can stand over 150kg weight for professional skateboarders.     Compatible Motor: 5055/5065/6355/6365/6374 Motor Mount: 30mm and 44mm hole distance  1. Maytech Brushless Outrunner Sensored Motors 2....

Read more

1. Remote Apperance: 2. Receiver wiring instruction with VESC or VESC based Controllers:  There's 2 ways to connect receiver and VESC: 1. Connect VESC signal cable to receiver PWM; 5V; GND (as above receiver pin definition) 2. You can also use UART:  Cross connection of Receiver TXD/RXD and VESC RX/TX: Receiver’s TXD>> VESC RX;Receiver RXD>> VESC TX, 5V and GND also need to be connected, better use stranded wire, wire length should be shorter than 20cm. VESC supports UARR and PWM(PPM) throttle control. When use with Maytech waterproof remote, you can select PPM and UART, and select corresponding control in remote...

Read more

  How to test motor KV with VESC? KV must test without load. To compatible with different kinds VESC, The default parameters are more conservative in the design of the motor running speed, if test by VESC, test value would be lower about 5% than actual value. Test KV would be different under different mode and parameters, KV would be higher when test in following situations: with hall sensor, high angle, FOC higher than in BLDC, V6 higher than V6.   What is KV? KV is unload rotation speed (RPM) per Voltage, which is the increasing speed value of brushless...

Read more

For motor run correctly, it is very important to set correct parameters in VESC_TOOL, follow below steps. Preparations before detection: Please detect motor without any load. Make sure that no other input such as PPM is used. If it is, it will stop the motor immediately when the detection tries to start it and the detection will fail. Make sure you have proper VESC_TOOL software is download in your computer. Connect your VESC to your computer.   Detection: BLDC Mode: suggest to detect in BLDC mode first. Step1: Choose BLDC mode in VESC_TOOL.           Suggest to...

Read more