underwater remote RSS

If can't pair MTSKR1905WF remote with our 300A ESC successfully, might has below reasons: 1. Please check if the receiver or ESC power (Internal receiver version) is always on. Before pairing, please make sure the receiver power or ESC (Internal receiver version) power is off first, then turn on the remote screen and "Pair" in main menu until 【Pairing...】shows on the screen, and then turn on the receiver or ESC (internal receiver version) power, remote will pair automatically in about 0.5 seconds.  2. Some customers all above pairing steps are correct, but still can't pair successfully, Why? Our 300A ESC...

Read more

The MTSKR2005WF remote has one 30V 3A Relay mechanical switch and one 20V 2A transistor electronics switch for esk8 lights, etc.  1. Relay Switch:  -When relay switch is in original position(no display of ① in Main interface) , COM(common point) and CLO(normally close) are connected. -When Short press Function button 3 times (display of ① in Main interface) , COM(common point) and OPE(normally open) are connected. Short press Function Button 3 times, relay switch is off. 2. Transistor Switch:  Short press Function button 4 times , ② will display on main interface, transistor switch source will be connected to GND and turn on LED. Short press...

Read more

When you received the MTSKR1905WF / MTSKR2005WF remote, firstly you need to connect receiver to your VESC / ESC, and pair the remote with receiver.  1. If you use VESC with built-in BEC, then just need to connect the throttle wire on ESC to receiver PWM port, receiver port definition as below, same as both MTSKR2005WF and MTSKR1905WF:      2. If you use OPTO without built-in 5V BEC, then you also need to add a 5V UBEC to power the receiver, wiring diagram as below:        3. After connected correctly, then do pair steps as below:  Firstly,...

Read more

We've got many times about this questions: How can I set the ESC values for my Efoil, today we will talk about this.  1. If you use our 300A ESC to work with our motor, then suggest you use the default values, because our engineer had already adjusted the values to make them work properly before shipment.  Default values is as below:  2. In second situation, if you use our ESC to work with other brands motors, you can use the default value to test at first, if not working, then you can try to adjust the values by progcard...

Read more

For motor run correctly, it is very important to set correct parameters in VESC_TOOL, follow below steps. Preparations before detection: Please detect motor without any load. Make sure that no other input such as PPM is used. If it is, it will stop the motor immediately when the detection tries to start it and the detection will fail. Make sure you have proper VESC_TOOL software is download in your computer. Connect your VESC to your computer.   Detection: BLDC Mode: suggest to detect in BLDC mode first. Step1: Choose BLDC mode in VESC_TOOL.           Suggest to...

Read more