VESC6.0 based controller RSS

  1. Maytech New 72V VESC Controller MTSVESC7.5R Round VESC based on VESC6.0 Hardware for Electric Skateboard Longboard Model No. MTSVESC7.5R Cont. Current 50A Burst Current 100A Input Voltage 72V Hardware Based on VESC6.0 Firmware  Updatable  Software VESC_TOOL Compatible FOC  Yes, can work  Size  Round Shape 88mm diameter * 22mm height Compatible Motor Sensored / Sensorless Motor   2. Maytech NEW 10S 42V VESC6.0 based Controller MTSVESC6.0M 30A VESC for Electric Skateboard E-scooter Model No. MTSVESC6.0M Cont. Current 30A Burst Current 50A Input Voltage 42V(10S) Hardware Based on VESC6.0 Firmware  Updatable  Software VESC_TOOL Compatible FOC  Yes, can work  Size  65mm*20mm   Compatible...

Read more

1. If a vehicle does not need mechanical brakes, but must be able to brake, it must use electronic brakes. The principle is that the kinetic energy on the motor and the load can be used as a generator through the DC motor to convert the kinetic energy into electrical energy. Then the electric energy is consumed by heating and charging.   2. The electric energy that is emitted must not only charge the battery, but also release the heat. What is the process? 2.1 At this time, VESC has to make a distribution, which current is used to charge...

Read more

1. Remote Apperance: 2. Receiver wiring instruction with VESC or VESC based Controllers:  There's 2 ways to connect receiver and VESC: 1. Connect VESC signal cable to receiver PWM; 5V; GND (as above receiver pin definition) 2. You can also use UART:  Cross connection of Receiver TXD/RXD and VESC RX/TX: Receiver’s TXD>> VESC RX;Receiver RXD>> VESC TX, 5V and GND also need to be connected, better use stranded wire, wire length should be shorter than 20cm. VESC supports UARR and PWM(PPM) throttle control. When use with Maytech waterproof remote, you can select PPM and UART, and select corresponding control in remote...

Read more

  How to test motor KV with VESC? KV must test without load. To compatible with different kinds VESC, The default parameters are more conservative in the design of the motor running speed, if test by VESC, test value would be lower about 5% than actual value. Test KV would be different under different mode and parameters, KV would be higher when test in following situations: with hall sensor, high angle, FOC higher than in BLDC, V6 higher than V6.   What is KV? KV is unload rotation speed (RPM) per Voltage, which is the increasing speed value of brushless...

Read more

Inf. File download link: https://cdn.shopify.com/s/files/1/0089/3065/6320/files/VESCDrivers.rar?v=1592371404   First Step: download the file in the above link, unzip the file Open Device Manager in your computer, find the device corresponding to the inserted USB device, if has no corresponding driver program, you’ll see an exclamation mark behind the device name, choose this device, right-click and select “Update Driver Program” Second Step: Choose “Browse your computer to find driver software” Third Step: Choose file folder with inf. File and install, remember to unzip you download. Forth Step: Go next and install And done:   There are totally 3 installation methods for VESC Driver:...

Read more