How to Wire on MTSKR1905WF Receiver Relay Switch and Transistor to Control Light and Water Pump?

How to Wire on MTSKR1905WF Receiver Relay Switch and Transistor to Control Light and Water Pump?

The MTSKR1905WF remote has one 30V 3A Relay mechanical switch and one 20V 2A transistor electronics switch to control Esk8 Light and Esurf Water Pump, etc. .

Suggest to use Relay Switch to control Water Pump, Transistor Switch to control Light. 

【Ready to Ship】Maytech New Remote for Electric Skateboard MTSKR2005WF V2 Waterproof Hand Remote

1. Relay Switch: 

Relay Switch show you how to control water pump with MTSKR1905WF remote

-When relay switch is in original position(no display of ① in Main interface) , COM(common point) and CLO(normally close) are connected.

-When Short press Function button 2 times (display of ① in Main interface) , COM(common point) and OPE(normally open) are connected. Short press Function Button 2 times, relay switch is off.

relay switch on MTSKR1905WF remote waterproof remote controller hand remote for electric skateboard elongboard mountainboard

2. Transistor Switch: 

MTSKR2005WF MTSKR20V2WF how to control light with this waterproof control light with transistor switch

Short press Function button 3 times , ② will display on main interface, transistor switch source will be connected to GND and turn on LED.

Short press Function button 3 times, ② will disapper on main interface, LED is off.

 

relay switch on MTSKR1905WF remote waterproof remote controller hand remote for electric skateboard elongboard mountainboard


Tags