|
Model No
|
MTO7052HBM |
KV
|
60 |
|
Idle Current
|
0.5A
|
Max Current
|
22A
|
|
Inpur Voltage
|
24-42V | Internal Resistance |
0.557-0.577
|
|
Max Pull
|
6700g
|
Hole Size
|
M8
|
|
Model No
|
MTSPF6.8 | Cont Current | 50A |
| Lipo Voltage | 3-12S (12.6V-50V) |
Burst Current
|
240A
|
| BEC | 5V | Software | VESCTOOL, |
| Hardware | Based on VESC6.0 hardware | Firmware | Updatable |
Only connect CAN L and CAN H ! GND pins and 5V should never be connected in a V6/V75 based SUPERFOC ESCs VESC array.
3. MTBLEV1 Bluetooth Module:
Model No.: MTBLEV1
Compatible Controller Hardware: V4 / V6 / V75 based SuperESC
Compatible Software: VESCTOOL App
Frequency: 2.4Ghz
ARM Processor: ARM Cortex-M0 32 bit processor
256kB flash&16kB RAM
PCB Size: 41mm x 21mm
Net Weight: 5g
Antenna Length: 90mm
Please noted:
Actual product you receive might be a little different from the picture, please subject to the actual product you receive.
Default connector on the bluetooth module is 8pin 2.0mm pitch, we match a 7pin 2.0mm pitch connector in the package, you can change on your own if your VESC is 7pin 2.0mm pitch port.
1. The bluetooth is developed for communication between controller and VESCTOOL via BLE, to display parameters on mobile phone, so you can monitor real time parameters on app easily.
2. Motor current, duty cycle, ERPM, motor power, motor temperature, battery voltage, battery current, MOS temperature, charging current, charging power, etc., are able to display through the bluetooth module.
3. You can adjust parameters for motor settings, Including General, BLDC, FOC, PID controllers, etc informations.
4. It supports VESCTOOL Compatible controller based on V4, V6.0, V75_300 hardware, please choose the correct hardware version of your controller, we will match compatible cable for you.
5. Firmware is updatable.
Related Products: (Click the following pictures to check more products)
Maytech MTSKR2005WF New Waterproof Remote for Esk8 Only with 3 Speed Modes
Maytech Brushless Outrunner Sensored Motors
Maytech VESCTOOL Compitable Controller:
