Maytech MTDU30A Dual 30A Drive Controller ESC with FOC Mode for Hub Motor/Belt-driven Motor Skateboard
Specifications of Maytech dual drive controller with FOC mode for hub skateboard electric longboard:
Model No | MTDU30A | PCB Size | 50x92x20mm |
Cont Current | 30A per motorx2 | Weight | 250g |
Burst Current | 75Ax2 | Lipo | 3-10s |
Two firmware versions: Hub motor version for Maytech hub motors; Belt-driven motor version for Maytech 5055-6374 motors
Please Notice ! ! !
If you are not use the ESC work with Maytech motor, please notice the following points before place order:
1. This ESC connector is 5.5mm female connector.
2. Check your motor is hall sensored or not, the ESC can only be work with hall sensored motor.
3. Check your motor version, is it belt driven motor or hub motor? then choose correct variation.
4. Check your motor pole number. The ESC can only be workable with hub motor of 28 poles; work with belt driven motor of 14 poles.
5. The following picture is our motor hall sensor pin sequence, before your test, please make sure that your motor hall sensor pin sequence is same with ours, so the ESC could be workable.

