News and Guidence. RSS

MTSKR1905WF remote is IP67 waterproof, it has Esurf and Esk8 modes, can use on both electric surfboard and electric skateboard, with cruise control function. 1. Hold 1905WF remote throttle trigger to the throttle % you want to set. 2. Then use your thumb to long press 1905WF remote brake trigger. 3. You will see throttle % on screen starts flashing. 4. Release 1905WF remote throttle trigger, cruise control set. If you want to exit cruise control, just short press the remote throttle trigger or brake trigger.  

What is encoder?  An encoder is a device that complies and converts a signal or data into a signal from that can be used for communication, transmission and storage.  What applications can use an encoder?  Encoder is widely used in cut-to-length applications, plotters, robotics, packaging, conveying, automation, sorting, filling, imaging, etc.,  How to connect encoder to Maytech VESCTOOL Compatible Controller?  Here take AS5047P magnetic encoder as example, usually to encoder need to remove pull-up resistor, here's a way that no need to remove pull-up resistor, connect "5V, GND, PWM, V, U" on encoder to controller hall sensor port.  Recommend VESCTOOL compatible...

ST Link updagrading manual:  Our Standard STLink USB only matches 4 pitch cable, there’s 2 different situation when use the STLink: If ESC connect to power, you can only connect the 4 ports: RST; SWDIO; GND; SWCLK If ESC do not connect power, then need to connect 5 ports: RST; SWDIO; GND; SWCLK; 3.3V Below is the example that doesn’t downloaded firmware successfully because didn’t connect power and 3.3V for ESC. Another reason for this situation: If only use 3.3V to power the ESC from STLink, this only suitable for small ESC, because big ESC requires high power consumption, 3.3V...

Check what differences for VESC PPM Control Modes and find suitable control mode for your usage:    Off: Nothing, motor if off and not working; Current: With brake and reverse, it controls the current to the motor and consequently the torque, it gives torque control (acceleration) but does not limit or try to control the speed, it control the currents flow instead of the speed. With just a slight of throttle the motor will spin at maximum rpm immediately. When load is added, the motor rpm will slow down. This allow you to steep climb hill at quite low speed...

Maytech Upgraded 200A VESC-tool Compatible MTVESC7.12 Overview:  Electric Motorcycles/scooters, electric offroad skateboards, go-karts, and robots, etc demands ESCs with high current, high voltage and small size, but traditional electric bicycle ESCs are large in size and small in current. Electric motorcycle ESC can meet the requirements in terms of voltage and current, but it has a very large volume, a heavy weight, and a very high price. Our VESC7.12 200A ESC has successfully solved these problems, Max 60V voltage, 200A current, tiny size and compact design, and very light weight. Specification: Model No.  MTVESC7.12 Dust-proof Yes Cont Current 200A Splash...