MTSKR20V2WF RSS

The MTSKR2005WF remote has one 30V 3A Relay mechanical switch and one 20V 2A transistor electronics switch for esk8 lights, etc.  1. Relay Switch:  -When relay switch is in original position(no display of ① in Main interface) , COM(common point) and CLO(normally close) are connected. -When Short press Function button 3 times (display of ① in Main interface) , COM(common point) and OPE(normally open) are connected. Short press Function Button 3 times, relay switch is off. 2. Transistor Switch:  Short press Function button 4 times , ② will display on main interface, transistor switch source will be connected to GND and turn on LED. Short press...

Read more

When you received the MTSKR1905WF / MTSKR2005WF remote, firstly you need to connect receiver to your VESC / ESC, and pair the remote with receiver.  1. If you use VESC with built-in BEC, then just need to connect the throttle wire on ESC to receiver PWM port, receiver port definition as below, same as both MTSKR2005WF and MTSKR1905WF:      2. If you use OPTO without built-in 5V BEC, then you also need to add a 5V UBEC to power the receiver, wiring diagram as below:        3. After connected correctly, then do pair steps as below:  Firstly,...

Read more

MTSKR2005WF is designed only for electric skateboard application, please do not use for electric surfboard.  Difference between MTSKR1905WF and MTSKR2005WF, check below chart: Can I use the MTSKR2005WF on electric surfboard? No, MTSKR2005WF only has Esk8 mode, don't have Esurf mode, no cruise control mode; Besides, MTSKR2005WF remote is only IP67 waterproof, enough for electric skateboard usage, but not enough for electric surfboard, MTSKR1905WF inside circuit is not only with glued, but also with nanometer coating double waterproof, and the screen is with 2 layers waterproof screen; At last, the throttle Zero is different, can't compatible with Esurf application. 

Read more