How to Display Volt, Current, RPM, Temp on Maytech Remote with TX and RX ?

Many customers asked how to display volage, current, rpm and temp on our MTSKR1905WF or MTSKR2005WF remote when work with VESC Controllers

1. You need to make a wire to connect VESC to receiver as below, if you order MTSKR1905WF or MTSKR2005WF remote, and VESC from us, we will match suitable wire for you: 

Connect VESC to receiver:

VESC TX -- Receiver RX

VESC RX -- Receiver TX

VESC 5V -- Receiver 5V

VESC GND -- Receiver GND


2. Adjust parameters in VESCTOOL:

APP Settings--App to use--Choose UART

APP Settings--UART--Baudrate--115200bps


3. Ajust parameters in remote:

  • Item 3.Batt Set Num: set correct battery series number according to your battery
  • Item 6. Data Source: choose "VESC"
  • Item 10. VESC Thr: choose "Current Mode", if use "PPM and UART" in APP Settings--App to use, then suggest to choose "None"
  • Item 7. Motor Poles: this is actually motor pole pairs number, so if your motor pole is 14, this value should be set to 7.

Notice: 1. Do not suggest to choose Duty Cycle for remote Data Source setting, if operate not well would easy damage the VESC and motor. 2. If you choose "PPM and UART" in APP Settings--App to use, then suggest to choose "None" in remote VESC Thr setting.

Check below video ↓ to better undestand:

블로그로 돌아가기