200A VESC RSS

When you received the MTSKR1905WF / MTSKR2005WF remote, firstly you need to connect receiver to your VESC / ESC, and pair the remote with receiver.  1. If you use VESC with built-in BEC, then just need to connect the throttle wire on ESC to receiver PWM port, receiver port definition as below, same as both MTSKR2005WF and MTSKR1905WF:      2. If you use OPTO without built-in 5V BEC, then you also need to add a 5V UBEC to power the receiver, wiring diagram as below:        3. After connected correctly, then do pair steps as below:  Firstly,...

Read more

The answer is no, here's 2 reasons: 1. Because switching power supply voltage can reach to 300V at the moment of power connected, then switching power need to adjust voltage to specific voltage (such as 20V, 35V), most switching power has slow response, the 300V voltage will directly burn controller driver chip and MCU, also may cause capacitor swell.   2. Connect power first (for example 35V), connect load, when load weight is too high, voltage will decrease (almost 30V),at this time switching power supply need to increase voltage to specific value (35V), but load weight is constantly changing, if load...

Read more

Progcard-HA User Manual Attention Please: If you want to program on progcard, do not connect progcard to computer, otherwise will use computer for programming, not program on progcard. Progcard Port Denifition: Compatible ESC: MTSF300A-OPTO, MTSF300A-OPTO-WP ESC has 2pcs three pins cable looks alike, please do not mix them , longer one is PWM throttle signal cable, short one is programcable, see below pictures: MTSF300A-OPTO MTSF300A-OPTO-WP internal receiver program cable MTSF300A-OPTO-WP external receiver program cable  3. How to connect progcard on ESC and program? You need to give extra 5V power to the program cable, otherwise progcard screen will not turn...

Read more

For motor run correctly, it is very important to set correct parameters in VESC_TOOL, follow below steps. Preparations before detection: Please detect motor without any load. Make sure that no other input such as PPM is used. If it is, it will stop the motor immediately when the detection tries to start it and the detection will fail. Make sure you have proper VESC_TOOL software is download in your computer. Connect your VESC to your computer.   Detection: BLDC Mode: suggest to detect in BLDC mode first. Step1: Choose BLDC mode in VESC_TOOL.           Suggest to...

Read more

All Maytech Products 20% OFF !!! Automatically Get 20% OFF Discount in Checkout !   How to get the 20% OFF Discount?   1. Add to cart and go to cart, then you can automatically get the discount   2. Buy it now   What is the Spring Sale 20% OFF Deadline?   The Spring Sale 20% OFF will be limited to 19th, March, 2020, so please confirm order asap before the deadline.    If you have any questions, please feel free to contact us. Email: maytech@maytech.cn Whatsapp/Wechat: +86 13575977294 Tel: 86-21-56165310

Read more