Maytech.cn
New Marine E Foil Kit 42V Waterproof 6374 80KV Motor + 130A ESC + MTSKR1905WF Waterproof Remote
New Marine E Foil Kit 42V Waterproof 6374 80KV Motor + 130A ESC + MTSKR1905WF Waterproof Remote
정가
$523.60 USD
정가
할인가
$523.60 USD
단가
단위
배송료는 결제 시 계산됩니다.
픽업 사용 가능 여부를 로드할 수 없습니다.
Application:
DIY foil assist on wing foil, wind surf foil, sup foil board, kite foil, underwater thruster, sup foil assist, paddle assist, wind foil board, sup board, downwind, hull cleaning device, underwater rov, underwater cleaning robot, boat cleaner, quariums or submerged environments, tank cleaning, underwater drone, etc.,
Aiming to convert non-electric foil boards to electric foil easily with reasonable cost.
> Check Test Datasheet
>How to Install Prop on Motor ?
>Check Underwater Test Video
>Using Instruction Video
>Check ESC Manual and Instruction
>Check V3.0 MTSKR1905WF Remote Manual and Instruction
>Check how to set bidirection for the ESC?
1. 6374 80KV Waterproof Motor
| Model No | MTO6374-80-WPC2 |
| KV | 80KV |
| Idle Current | 0.8A |
| Max Current | 102A at 42V |
| Rated Current | 60A |
| Input Voltage | 6-10S Lipo (24-42V) |
| Max Output Watt | 4.3KW |
| Shaft | No output shaft |
| Hall Sensor | Without |
| Waterproof Rank | IPX8 |
| Cable Length | 1m |
| Cable Guage | 3x 12AWG |
| Connector | 4.0mm Male bullet connector |
| Bearing | Stainless stell bearing |
| Customize | KV, logo, shaft, mounting hole pattern, color, connector, cable, etc. contact agnes@maytech.cn |
2. MTSF130A-WP32 130A 32Bit IP68 Waterproof ESC:
| Model No. | MTSF130A-WP32 |
| Waterproof Rank | IP68 |
| Cont Current | 130A |
| Peak Current | 150A |
| Input Voltage | 6-10S Lipo (24V-42V) in this kit |
| BEC | With 5.5V/2A BEC |
| Connector |
With 3x 4.0mm female bullet connector on motor cable side No connector on battery cable side |
| MCU | 32BIT Micropprocessor |
| Test | We will set workable parameters fot the ESC and run test to make sure it work well with the 6374 80KV motor before shipment |
3. MTSKR1905WF V3.0 IP67 waterproof remote
| Model No | MTSKR1905WF V3.0 |
| Waterproof Rank | IP67 double waterproof |
| Thr Mode | ESURF (SF) and ESK8 (SK) |
| 3 Speed Modes | With, adjust throttle % from 20-100% |
| Power Modes | 2 levels, Eco (Level 1) < Pro (Level 2) |
| Throttle Lock | Yes, 10-30S optional |
| Signal Format | Support Standard PWM (PPM) and UART, output range from 10%-20%, which correspond to ESC/VESCTOOL Compatible controller throttle output range from 0%-100%. |
| PWM Signal Output Range | 1ms-2ms for throttle no brake in Esurf mode; 1.5ms-2ms for throttle, 1.5ms-1ms for brake in Esk8 mode. |
| Double Source Power Supply | Accept 5V power by ESC built-in BEC or extra 5V power |
| Output Signal | Max 3.3V |
| Display Parameters |
Signal strength, remote and battery power bars, battery voltage, RPM with VESC and other ESCs |
| Control Pump | Yes (Relay Switch) |
| Control Light | Yes (Transistor Switch) |
| Safety Button | Support |
| Cruise Control | With in Esurf Mode |
| Brake | With in Esk8 Mode |
| Accessories | Wirelss charging pad / Receiver / USB cable / Wristband / 3pcs Dupond cable |
| Compatible Controllers | VESC/ Focbox/ Other PWM ESCs that has same signal output range with the remote. |
| Application | foil assist system, electric propulsion, underwater thruster, electric outboard, Esurf, Efoil, electric hydrofoil, electric surfboard, electric skateboard/ elongboard/ mountainboard, electric paraglider, etc., |
> Get E-Manual: Remote Manual and Instruction
> Check Video Using Instruction
Click Here: How to Display Volt, Current, RPM with TX and RX?
4. Customer's Feedbacks ！
Stock Notice Before Place Order:
1. The motor 150KV is in limited stock, so please confirm your order asap, or please contact us agnes@maytech.cn to check stock first if you need very urgently.KV can be customized, if you want to customize, we can do for you, please contact us for the KV you want.
2. Shipping time is about 24 working hours after your order confirmed for stock item, if not in stock, lead time is about 30-40 days.
3. Motor wire leads out position is specific, if wind one more circle or one less circle, the KV would differ much, hard to make exact KV, so each motor might has ±5%-10% tolerance, this is normal.
