How to Set Parameters in Remote When Use with Different ESCs / VESC?
Maytech MTSKR1905WF V3.0 Remote can display RPM, battery remain voltage %, current/voltage/temperature, when work with different ESCs or work with VESC, wiring diagram, settings in remote and parameters displat are are all different. Because some customer may confuse and can't make the remote display parameters correctly, so here we will show you the correct thing to do, here we set parameters for Surfboard Mode:
1. When work normal ESC such as MTSF160A-WP32 / MTSF130A-WP32 :
With this type ESC, except for usual parameters, remote can display RPM, battery power bar and remain voltage % if you wire and set parameters correctly.
1. Display battery bar and voltage %: Lead out a wire from your battery + to "BAT" on receiver
2. Display RPM: Lead out a wire from one of 2 motor wires, connect to "MOT" on receiver.
3. Setting in remote for this kit:
| 1)Thr Mode: | Surfboard |
| --5) and 6) Batt Type and Batt Ser Num | Please set according to your battery. |
| 9) Data Source |
1. If you connected MOT for RPM display, then select 【Motor Wire】 2. If you don't connect MOT for ROM display, only need to display battery bat and voltage %, then select 【None】 |
| 10) M.Pole Pairs | According to motor pole pair number |
| 12) Gear Ratio | 1.0 |
| 14) VESC Thr | None |
If use Maytech MTSF300A-WP / MTSF500A-WP ESC, parameters settings same as above, wiring instruction as below:
2. When work Maytech MTSF300A-WP32 / MTSF300A-WP32-HV ESC:
1. Display battery bar and voltage %
2. Display RPM
3. Display real time voltage/current/temperature
4. Setting in remote for this kit:
| 1)Thr Mode: | Surfboard |
| --5) and 6) Batt Type and Batt Ser Num | Please set according to your battery. |
| 9) Data Source |
MTSESC-WP32 |
| 10) M.Pole Pairs | According to motor pole pair number |
| 12) Gear Ratio | 1.0 |
| 14) VESC Thr | None |
3. When work VESC type controllers:
1. Display battery bar and voltage %
2. Display RPM
3. Display real time voltage/current/temperature
4. Setting in remote for this kit:
| 1)Thr Mode: | Surfboard |
| --5) and 6) Batt Type and Batt Ser Num | Please set according to your battery. |
| 9) Data Source |
VESC |
| 10) M.Pole Pairs | According to motor pole pair number |
| 12) Gear Ratio | 1.0 |
| 14) VESC Thr | Current |
